ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Using Guide Points
Creating Standard Paths
Special Creation Methods For Paths
Create one or several guide points. When creating paths, specify the
starting and ending point of the two paths on these points.
Or create the path first and then generate automatic guide points.
For more details refer to Guide Points (page 6-5) and Automatic Guide
Points (page 6-5).
Transferring Values
http://www.image2output.com
In addition to coordinates, you can also store angles, lengths, radii etc.
and recall these values for the same or a different path.
Example: Creating two circles with exactly the same radius.
1. Select PATHS | CIRCLES & ARC | CIRCLE RADIUS.
2. Specify the center of the first circle, e.g. by clicking on the layout.
3. Define the radius, e.g. as follows:
Click on the layout, move the mouse vertically, then click again.
4. Press F2, click or select EDIT | SAVE VALUE.
5. Specify the center of the second circle.
6. Press SHIFT+F2, click or select EDIT | APPLY VALUE.
7. Press ENTER, or select any other function. A circle with the stored radius
appears.
Note:
A stored value remains stored until it is overwritten by reselecting SAVE
VALUE. Saving and applying values is not possible if the Rectangle Editor
is active.
ORIS PDF Tuner Version 4.4.8 User Manual 7-13
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com