ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Transparency and Soft Edges
Creating Transparency for Layers
MATRIX
LINEWORK
TRANSPARENCY
http://www.image2output.com
Same as COMPLEX, but allows you to specify values
using a two-dimensional matrix (see page 17-4).
Allows you to set individual separations of linework
to 100% transparent (see page 17-6).
3. Additional options (see also Dialog Buttons, page 17-7):
• Click STORE to save the current transparency parameters.
• Click ALL OPAQUE to remove any transparency.
• Click RESET to restore the parameters that existed when the
dialog was opened.
‘Simple’ Tab (Transparency, Trapping...)
Use this dialog tab to set the transparency of all 4 color separations to
the same value. You can use the slider or enter the degree of transparency
into the input box.
Fig. 17-1
‘Simple’ Tab (‘Transparency, Trapping, Soft Edges’ Dialog)
Complex Settings
Use this option to decide how to handle complex transparency settings
previously made on the COMPLEX and MATRIX tabs (see below), e.g. color
transformations achieved by adding parts of the Magenta separation
to the Cyan separation.
• The KEEP COMPLEX SETTINGS setting adds the new transparency to
any existing complex transparency. If you switch to the MATRIX tab
afterwards, you can see that only the values on the two matrix diagonals
(C/C, M/M, Y/Y, K/K) have changed, other values remain
unchanged.
• The RESET TO SIMPLE TRANSPARENCY setting cancels any existing
complex transparency settings. If you switch to the MATRIX tab afterwards,
you can see that all values not located on the two diagonals
have changed to 0.
17-2 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com