ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Exporting Layouts
‘Page Marks’ Tab
Crop size
Using this option you can define the same amount of bleed for all documents.
The specified value will be added to each of the four page edges,
i.e. the page format increases.
If bleed is defined already for a page, the bleed will be enlarged or reduced
to the specified size. This means that the net page format (format
without bleed) remains the same.
Area format
Use these parameters to output a section of a document only. This allows
you to crop a page to a particular size, for example, or to output the
right or left side of a two-page spread.
Select the size of this section from the AREA FORMAT list or enter the
width and height into the AREA SIZE X/Y boxes. Use the PORTRAIT/
LANDSCAPE options to swap width and height. Use the AREA OFFSET X/Y
boxes to specify the location of the section’s lower left corner.
Example
To output the right half of an A3 landscape page (420 x 297 mm), select
A4 format, click the PORTRAIT option and enter 210 into the AREA OFFSET
X box and 0 into the AREA OFFSET Y box.
Fig. 3-17
297
Y
Outputting a Page Section
0 210 420
‘Page Marks’ Tab
0
X
All except
EPS
Use this tab to create additional objects on the output documents such
crop marks, color bars or information text. These objects will be placed
inside the bleed margins or, if none are defined, outside the page borders
(i.e. page size increases).
ORIS PDF Tuner Version 4.4.8 User Manual 3-41
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com