ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Working With Paths
Correcting Paths
In the STATUS window the selected value is indicated in boldface type.
If it is a coordinate, the corresponding point is marked by a cross.
Example when correcting a circle:
5. Modify this parameter by doing one of the following:
• SHIFT-click, then move the mouse. Press the mouse button when
the value you want is reached.
• Enter the value on the keyboard (direct input, see page 29-7).
The next value is selected automatically.
6. Repeat these steps until you have corrected all parameters.
7. End the function, e.g. by clicking or selecting any other function.
If, instead of this, you click on the layout after correcting the last
value, a new path of the same type will be created.
Annotations
You can only correct one path at a time. Only the path activated first is
taken into account if several paths are active.
Correcting a framed path removes the frame (see also page 8-10).
The RECTANGLE EDITOR (see page 7-2) is used when you are correcting
rectangles, framed grids, grids split into rectangles, framed parallel lines
or frames created for highlighting text characters.
Note:
Correcting a path using its creation function is no longer possible once
the path has been...
• distorted perspectively, skewed or scaled unproportionally (see also
Transformations, page 19-1)
• edited using PATHS | EDIT | SEPARATE or COMBINE (see page 8-6)
• modified using the Path Editor (see page 9-1)
Such paths are no longer Standard Paths, but so-called Combined
Paths and can only be modified using the Path Editor.
ORIS PDF Tuner Version 4.4.8 User Manual 8-5
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com