ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Reference
Units and Values
Unit Abbreviation Equivalent
Relative units dmm
dinch
dpt
d special
Distance from a specific coordinate
measured in millimeters,
inches, points or special units
respectively
Annotations
The units Didot Point and Pica Point are fixed values. Each corresponds
to 1/12 of the Cicero or Pica value respectively. The unit POINT, however,
can be defined by the user.
To define the units POINT and SPECIAL, use the FILE | SYSTEM SETUP |
SPECIAL UNITS function. For more details refer to page 31-4.
See also Combining Cicero/Pica and Point Units (page 32-14).
Entering Units Together With Value
In most dialogs you can enter the abbreviation of the unit into the input
box of the numeric value. You only need to type the minimum numbers
of characters necessary to clearly identify the unit. Usually it is sufficient
to type the initial letter. The abbreviation is not case-sensitive.
Selecting Units from a List
In all dialogs you can select units from a menu located to the right of the
input box. When you click the small arrow, a list of units opens. Having
selected a unit, the current value is automatically converted into the new
unit (but not in the case of a direct input, see page 29-7). The following
figure shows an example:
Fig. 32-3
Selecting Units from a List
In some dialogs (e.g. that of the Rectangle Editor) there is no menu for
selecting units. Instead, the input box for the numeric value is designed
as a list of the same value converted into different units. The following
figure shows an example:
ORIS PDF Tuner Version 4.4.8 User Manual 32-13
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com