ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
16 Modifying Layers
Activating Layers
Every printable object on a layout resides on a separate level and is
therefore referred to as a layer. To be able to modify a layer, you must
make it active. Usually the easiest way to do this is to click on it, but there
are also other methods to activate a layer which are explained below.
Activating layers is only possible if the layer selection mode is enabled.
It is by default. If it isn’t, click , press F8, or select LAYER | ACTIVATE.
The layer selection mode is enabled if the toolbar button is displayed as
being pressed down or if a check mark is displayed next to the LAYER |
ACTIVATE function.
Fig. 16-1
Indication of Layer Selection Mode
Enabled
Disabled
Active layers are indicated by a mask which covers the layer entirely.
The default color of this mask is magenta. You can change this color using
the FILE | SYSTEM SETUP | DISPLAY COLORS function (see page 31-2).
Using VIEW | MASKS TRANSPARENT you can toggle between a transparent
and opaque mask display.
Fig. 16-2
Mask Indicating Active Layer
No layers selected
One layer selected
ORIS PDF Tuner Version 4.4.8 User Manual 16-1
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com