ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating Standard Paths
Creating Lines
http://www.image2output.com
3. If you want to close the path accurately, select CLOSE PATH from the
MENU window. This connects the first and the last point.
Smooth Lines with Points and Angles
Function SMOOTH LINE 3 allows you to create a curved line. The degree
to which the line is bent is defined by an angle.
1. Select PATHS | SMOOTH LINES | SMOOTH LINE 3.
2. Click to position the line’s first point or enter the point’s coordinate.
3. Define the curve angle by doing one of the following:
• Click on the layout to set another point.
• Enter the angle on the keyboard (direct input, see page 29-7).
4. Specify additional angles and points in the same way.
You can create a corner by specifying the same coordinate twice.
Creating Parallel Lines
You can create any number of horizontal, vertical or inclined lines running
parallel to each other.
1. Use the following functions on the PATHS | GRID & LINES menu:
HORIZONTAL PARALLEL LINES
VERTICAL PARALLEL LINES
INCLINED PARALLEL LINES
2. Click on the layout to set the starting point of the first line. Alternatively,
enter the point’s coordinate directly on the keyboard.
3. Do the same to set the end point of the last line.
4. Define the number of lines to be created between these two lines.
• Click on the layout, move the mouse vertically until the desired
number of lines is reached, then click again.
• Or enter the value directly on the keyboard.
See also Framing Parallel Lines (page 8-14).
7-8 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com