ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating Circles And Ellipses
Circle: Center and Radius
Creating Standard Paths
Creating Circles And Ellipses
How to create a circle by specifying the center and the radius:
1. Select PATHS | CIRCLES & ARC | CIRCLE RADIUS.
2. Position the circle center by clicking on the layout or entering the
coordinate on the keyboard (direct input).
3. Define the radius by doing one of the following:
• Click on the layout, move the mouse vertically until the radius
has the size you want, then click again.
• Enter the value directly on the keyboard.
Circle: 2 Points
How to create a circle by specifying the center and a point on the circle:
1. Click or select PATHS | CIRCLES & ARC | CIRCLE 2 POINTS.
2. Position the points by clicking on the layout or entering the coordinates
on the keyboard (direct input).
Circle: 3 Points
How to create a circle by specifying three points on the circle:
1. Select PATHS | CIRCLES & ARC | CIRCLE 3 POINTS.
2. Position the points by clicking on the layout or entering the coordinates
on the keyboard.
Ellipses
http://www.image2output.com
There is a function for creating straight ellipses and one for inclined ellipses.
In both cases you have to specify three points.
1. Select PATHS | ELLIPSE or INCLINED ELLIPSE, respectively.
2. Specify three points on the outline of the ellipse.
To do so, click on the layout or enter the coordinates on the keyboard.
The inclination of inclined ellipses can only be defined by the position of
the second point. It is not possible to do this by specifying an angle.
ORIS PDF Tuner Version 4.4.8 User Manual 7-9
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com