ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Importing PDF and PostScript Files
‘Page’ Tab
http://www.image2output.com
Page size X/Y, Page offset X/Y
If you have set the DEFINE PAGE SIZE AND OFFSET BY parameter to USER
INPUT, use the PAGE SIZE/OFFSET boxes to define the section of the PDF/
PS/EPS document to be imported. All page elements located completely
outside this section will be omitted.
Use the PAGE SIZE boxes to specify the size of this document section and
the PAGE OFFSET boxes to specify the position of the section’s lower left
corner. To import the right half of an A3-sized landscape PDF document
(420 x 297 mm), for example, specify the following values:
PAGE SIZE X: 210 mm PAGE OFFSET X: –210
PAGE SIZE Y: 297 mm PAGE OFFSET Y: 0
Fig. 2-4
297
Y
Importing a Page Section
0
0 210 420
X
Rounding values
Using this parameter you can round up the size of the PDF/EPS/PS documents
you are importing or converting, e.g. to the next full millimeter. If
the page origin (offset) is not 0/0, it will be rounded down. Select NONE
to use the original unrounded page size of the PDF/EPS/PS document.
This parameter is not applied if the DEFINE PAGE SIZE AND OFFSET BY parameter
is set to USER INPUT.
Note:
QuarkXPress version 5.0 creates the internal page size value of Post-
Script files with decimal places. The page size value written to the information
section of a PS file and displayed in the dialog under INFORMA-
TION FROM PS/PDF FILE, however, is created in the same way as before.
Rounding up or down may therefore produce page size values which differ
up to one millimeter from the expected rounding value.
Mode
If you are rounding the page size, use this parameter to specify how this
should be done. The following options are available:
2-6 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com