ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating and Opening Pages
‘Layout Parameters’ Dialog
If there are any unsaved modifications you are asked if they should be
saved.
‘Layout Parameters’ Dialog
http://www.image2output.com
Use this dialog to make basic settings for the current layout such as
page size, origin of coordinate system and bleed margins. The parameters
are explained below.
This dialog appears automatically when you create a new layout. The
settings can be changed at any time using the FILE | LAYOUT PARAME-
TERS command.
Fig. 5-1
‘Layout Parameters’ Dialog
Note:
Format, Width, Portrait...
Select a predefined page size from the FORMAT list or enter the size you
want into the WIDTH and HEIGHT boxes. Using the PORTRAIT and LAND-
SCAPE options you can swap width and height.
Type the unit of measurement into the WIDTH and HEIGHT input box or
select it using the lists next to the ORIGIN POINT boxes (see page 32-12).
Having changed the layout size, close the dialog and select VIEW | COM-
PLETE PAGE ( +0 or CTRL+0). This reloads the layout and displays it in
a way that it fills the entire window.
The layout borders are indicated by a narrow yellow line. Layer parts exceeding
the layout borders will not be printed or exported. However, the
area outside the layout borders may be used to temporarily ‘store’ layers
which are required at a later stage of the page assembly process.
ORIS PDF Tuner Version 4.4.8 User Manual 5-7
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com