ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Exporting Layouts
Using Bleed Pages
http://www.image2output.com
Creating Bleed or Trim Margin Lines
Bleed pages can also be used for adding bleed or trim margin lines to a
document. Lines and other objects on a bleed page are scaled according
to the size of the document you are processing, provided that:
• You have flagged the objects using the MARK function in the MENU
window (see Marking Layers for Layout Export, page 16-17).
• The object extends into the opposite area (refers to the 9 areas on a
bleed page, see Fig. 3-28 above). The lower left corner must be
located in one area and the upper right corner in the opposite area.
Objects are scaled horizontally and/or vertically, depending on the areas
where they begin and end, as shown in the following table:
From area – to area
Scaling applied to…
1–3, 8–4, 7–5 Width only
1–7, 2–6, 3–5 Height only
1–5, 7–3 Width and height
If a bleed page contains a rectangle defining the page size without bleed,
for example, the rectangle will be enlarged to the page size of the document
you are processing (see figure below).
There is a certain tolerance for the areas 1–8. It amounts to 25% of the
width or height of the document being processed. This means that objects
are also scaled if they slightly extend inwards beyond these areas.
This allows you to create type margin lines, for example.
3-66 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com