ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Exporting Layouts
Defining Trapping Rules and Exceptions
To edit a trapping profile, click the or button. This opens the TRAP-
PING PARAMETERS dialog. Use the parameters on the BASIC SETTINGS tab
to modify the trapping rules.
See also Defining Trapping Rules and Exceptions (page 3-55).
Area
Use this input box to specify the amount of trapping to be used, i.e. the
size of the chokes and spreads.
The trap area should not be wider than the thinnest line on the page.
Defining Trapping Rules and Exceptions
You can modify the basic rules for calculating automatic trapping and
also define trapping exceptions. These parameters must be stored as a
trapping profile, which is then available on the TRAPPING/SOFT EDGES
tab. The trapping parameters can also be exported to a file. This allows
you to use the same settings in ORIS Works hotfolders which do not support
the definition of trapping rules and exceptions (see also page 3-60).
To define trapping rules and exceptions, select the TRAPPING/SOFT ED-
GES tab and click on the or button displayed next to the current trapping
profile. This opens the TRAPPING PARAMETERS dialog. Select the BA-
SIC SETTINGS or EXCEPTIONS tab.
Profile
Use the list at the top of the dialog to select a trapping profile. A trapping
profile is a set of parameters defining trapping rules and exceptions, i.e.
the profile includes the parameters used on both dialog tabs.
Use the SAVE AS button to create a profile and DELETE to delete the selected
profile. You can replace an existing profile by saving it under the
same name.
The STANDARD profile contains the program’s default settings. It can neither
be modified nor deleted.
ORIS PDF Tuner Version 4.4.8 User Manual 3-55
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com