ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Creating Standard Paths
Correcting Standard Paths
Arc
1. Select PATHS | CIRCLES & ARC | ARC.
1. Specify the first, the second and then the last point of the arc.
To do so, click on the layout or enter the coordinates on the keyboard
(direct input).
Note: When framing an arc using or it will have straight corners. To create
a framed arc with rounded corners use PATHS | CIRCLES & ARC | FAN.
Framed Arc (‘Fan’)
How to create a framed arc with rounded corners:
1. Select PATHS | CIRCLES & ARC | FAN.
2. Specify the first, the second and then the last point of the arc.
To do so, click on the layout or enter the coordinates on the keyboard.
3. Specify the width of the frame by doing one of the following:
• Click on the layout, move the mouse vertically until the desired
width is reached, then click again.
• Enter the value directly on the keyboard.
Correcting Standard Paths
All values (points, angles, radii, etc.) of a standard path can be corrected.
This is possible both during the creation and afterwards. For more details
refer to page 8-4.
Special Creation Methods For Paths
Closing Paths Accurately
To close open paths (e.g. CONNECTED POINTS) accurately you must
specify exactly the same coordinate for the starting and ending point.
There are various ways to do this.
Using ‘Close Path’ Function
For certain paths function CLOSE PATH is available in the MENU window
during creation. This function connects the point specified last with the
first point.
ORIS PDF Tuner Version 4.4.8 User Manual 7-11
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com