ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating Text and Headlines
Creating Text Runarounds
‘Text Displacement Parameters’ Dialog
Use this dialog to define the parameters of a layer that displaces the text.
Select a displacement mode and define the distance between the text
and the displacing layer. The parameters are explained below.
Displacement Mode
http://www.image2output.com
Text will not be displaced
Use this option to switch off text displacement.
Text will be displaced by rectangle
This option is only available if the layer was created using a rectangle.
The rectangle must have normal corners and all angles must be exactly
90°. It may be straight or inclined. The text will run around the outline of
the displacing layer.
Text will be displaced by bounding box
With this option the text will run around an assumed straight rectangle
enclosing the outline of the layer.
Text will be displaced by contour
With this option the text will run around the outline of the displacing layer.
Fig. 12-9
Text Runarounds (Examples)
Displacement by...
Contour Bounding Box Rectangle
Displacement Offset
Use these parameters to define the distance between the text and the
displacing layer.
If text displacement is by rectangle or bounding box, you can specify different
distances for the four rectangle sides. Enter these values into the
LEFT, RIGHT, TOP and BOTTOM boxes.
If text displacement is by contour, all distances are equal. In this case enter
the offset value into the DISTANCE box.
ORIS PDF Tuner Version 4.4.8 User Manual 12-25
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com