ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Modifying Layers
Activating Layers
http://www.image2output.com
The STATUS window (see page 16-20) displays the total number of active
layers (under SELECTed LAYERS) and the number of the CURRENT LAYER,
i.e. the layer selected last.
Activating a Single Layer
Take one of the following actions:
• Click on the layer.
• Enter the layer number (direct input, see page 29-7).
• Select TOP LAYER in the MENU window to activate the topmost layer
(the layer with the highest layer number).
• Repeatedly CTRL-click (Mac OS) or right-click (Windows) on the layout
to activate the next layer (i.e. that with the next higher number).
Additionally press the SHIFT key to activate the previous layer (i.e.
that with the next lower number).
If multiple layers are active already, they will remain active, unless
switching to the layer selection mode has been your last action.
Note:
To activate a text that was not set into a path, click on any of its characters.
If the text was set into a path, however, it is sufficient to click anywhere
inside the text area.
Activating Multiple Layers
Take one of the following actions:
• To add a layer to those which are active already, SHIFT-click it or
enter its layer number (direct input, see page 29-7).
• Draw a selection rectangle enclosing all layers you want to activate
(see Fig. 16-3).
• Draw a selection rectangle with the SHIFT key pressed down to add
the selected layers to those which are active already.
• To activate all layers, press +A (Mac OS) or CTRL+A (Windows).
Alternatively, use EDIT | SELECT ALL or select SELECT ALL in the
MENU window.
This does not activate the layout’s background layer (#1).
16-2 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com