ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Using the Path Editor
Modifying Paths
A single point can also be deleted as follows:
1. Place the cursor on the point to be deleted.
2. Hold the SHIFT key pressed down and drag the point on top of one of
the neighboring points. This is only possible if these points are not
marked.
As you move the mouse, the neighboring points change in color (default
is magenta). A minus sign (–) appears when the two points are
on top of each other. The point is deleted as soon as you release the
mouse button.
Closing Paths
There are two methods to close a path.
Creating a new path segment that connects the two end points:
1. If there is more than 1 path, select the path to be closed (see above).
2. Select CLOSE PATH in the MENU window.
Moving one end point on top of the other:
1. If no points are displayed for a path, SHIFT-click on this path to display
all of its points.
2. Position the cursor on one of the path’s end points.
3. Hold SHIFT pressed down and drag this point on top of the other end
point. This is only possible if the end point is not marked.
As you move the mouse, all end points change in color (default is magenta).
A circle appears near the cursor when the two end points are
on top of each other. The two points are combined into one as soon
as you release the mouse button.
Opening Paths
To open a closed path:
1. Activate the point at which the path is to be opened (see above).
2. Select OPEN PATH in the MENU window.
The path is cut at the active point and two end points covering each other
are created. You can now move the active point away from the point located
below it.
ORIS PDF Tuner Version 4.4.8 User Manual 9-9
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com