ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Retouching
How to Retouch
http://www.image2output.com
Selecting Brush Display
Use this button to define how the brush is displayed:
The brush is displayed as a square or circle,
according to the current brush shape.
The brush is always displayed as a cross,
regardless of the current brush shape.
Retouching Parameters
Setting Color Density
Use this slider or input box to define the color density. Brushing with a
density under 100% allows image areas to show through the brushed areas.
Density can be set between 0% (transparent) and 100% (opaque).
Note that this only defines the initial color density. When you brush repeatedly
over the same image area, color density will increase beyond
the specified value up to 100% or up to the specified density limit.
To specify a mask density limit, enable the MAX. DENSITY option and enter
a percentage value into the input box. The value defaults to the current
color density. Now the color density will never exceed the specified
limit, even if you brush repeatedly over the same image area and regardless
of the specified (initial) color density.
Tip:
To prevent new brush strokes from overwriting color areas painted previously,
select FIX CHANGES in the MENU window. This saves the image
temporarily. When you now brush over previously painted areas using a
color density lower than 100%, these color areas will show through.
See also Saving and Reversing Changes (page 23-12).
23-8 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com