ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating Standard Paths
Special Creation Methods For Paths
Saving First Point
http://www.image2output.com
For all paths it is possible to store and later recall the starting point:
1. Select the function that creates the path and set the starting point.
Note:
2. Press F2, click or select EDIT | SAVE VALUE.
3. Specify the values required for creating the path.
4. Instead of setting the last point, press SHIFT+F2, click or select
EDIT | APPLY VALUE. The ending point is placed on exactly the same
position as the starting point.
Saving and applying values is not possible if the Rectangle Editor is active.
Using Guide Points
Create a guide point and set the first and last point of the path on this
point.
Or generate automatic guide points after creating the open path. Then
connect the starting and ending point with a new path.
For more details refer to Guide Points (page 6-5) and Automatic Guide
Points (page 6-5).
Connecting Paths
It is possible to connect two paths (of different or identical type) by specifying
points on the same coordinate. There are several ways to do this.
By Storing And Applying Values
1. Create the first path.
Having specified the point at which you want to connect the path,
press F2 click or select EDIT | SAVE VALUE.
2. If you want to connect it to a path of a different type, select the function
that creates this path.
3. Press SHIFT+F2, click or select EDIT | APPLY VALUE to specify the
point in which the two paths should be combined. A new point is set
automatically on the stored coordinate.
Note:
A stored value remains stored until it is overwritten by reselecting SAVE
VALUE. Saving and applying values is not possible if the Rectangle Editor
is active.
7-12 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com