ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating Dummy Text
‘Dummy Text Parameters’ Dialog
Typesetting Parameters
Select the alignment you want to use by clicking one of the options to the
right of ALIGNMENT. These options have the following meaning:
BLOCK Right and left aligned
LEFT Left aligned, right ragged
CENTER Centered, right and left ragged
RIGHT Right aligned, left ragged
Unless you have selected BLOCK, you can define the size of the margin
in which the text is wrapped to the next line. Use the ALIGNMENT AREA
box for this purpose.
Area Parameters
http://www.image2output.com
Note:
Adjustment
This parameter defines the vertical position of a dummy text relative to
the upper line of the path into which it will be inserted.
Baseline
The distance between the upper line of the path and the first baseline
corresponds to the leading. Text areas with identical leading can thus be
set in register even if different font sizes are used, i.e., the baselines of
such areas are always set on exactly the same vertical position.
Characters in the first line may exceed the path. If the font size is larger
than the path, the line only appears if the leading is decreased accordingly.
Baseline descender
This adjustment is identical with BASELINE. In addition, descenders do
not exceed the lower line of the path. The distance between the lower
line of the path and the last baseline is 1/3 of the font size.
Top point
The body’s top of the first inserted line touches the upper line of the path.
The distance between the upper line of the path and the first baseline is
equal to the font size.
Top capital
The cap height’s top of the first inserted line touches the upper line of the
path. The distance between the upper line of the path and the first baseline
is 2/3 of the font size.
14-4 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com