ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Tips and Tricks
Direct Input
http://www.image2output.com
• When creating a path using you can define the position of the
points you are connecting by entering the coordinates directly on the
keyboard. A dialog like that in Fig. 29-3 (bottom) appears.
Fig. 29-3
‘Manual Entry’ Dialog for Direct Input
Using ‘Manual Entry’ Dialog
Activating Next Box
Press the TAB or RETURN/ENTER key. Pressing RETURN/ENTER when the
last box is active closes the dialog and applies the specified values.
Specifying Units
Select the unit of measurement from the list. Alternatively, enter the initial
letter of the unit on the keyboard while the input box or the unit list is
active. Pressing the D key selects the dmm, dinch, dpt or dspecial
unit or toggles between these units, respectively.
The units dmm, dinch, d pt and d special are relative units, i.e. they
refer to the coordinate specified last. The unit d special is the relative
special unit. When changing the unit, the numeric value is not converted
into the new unit.
Related topics:
See also Defining Units of Measurement (page 31-4).
Entering Relative Values (see below)
Supported Units and Their Abbreviations (page 32-12)
Specifying User-Defined Points (‘PT’)
If the unit pt (user-defined Points) is selected, you have to enter the values
in the following format: Cicero or Pica – Points – 1/10 Points, all separated
by a period.
For example, 2.10.5 pt means 2 Cicero or Pica and 10.5 points. To specify
half a point you must enter 0.0.5 pt or .0.5 pt.
29-8 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com