ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Exporting Layouts
Using Bleed Pages
The text that replaces the PLATE variables is automatically set in the color
that corresponds to the respective color separation. This text overprints,
allowing you to position all PLATE variables on top of each other.
Note:
If you want bleed page layers to appear on all separations – including
spot colors, make sure you fill them with a color defined in the REGISTER
MARKS color space. See also page 10-10.
How to Position Elements on a Bleed Page
Page elements that should appear outside the page borders, e.g. crop
or register marks, must be placed within the bleed margins of the bleed
page. Thus they will always be printed outside the borders, regardless
of the page size.
Layers not placed inside the bleed margins (i.e. placed on the actual
page) will appear on the page itself. This feature may be used for printing
the text Demo across every page, for example.
To understand how and where layers are positioned on the output document,
note that the program divides the bleed page into 9 areas. The
same areas are created on the output document, but outside the page
borders – except for area 9, which is created in the center. This is illustrated
by the following example:
Fig. 3-28 Areas on a Bleed Page
Format of page
that was merged
Bleed Page with bleed page *
1
8
2 3
9
4
Area no. 2
Lower left
area corner
Bleed margin *
Page format *
Area no. 4
1
8
2 3
Output Document
9
4
7
6
5
Lower left
area corner
*)
As defined in the LAYOUT PARA-
METERS dialog (see page 5-7).
7
6
5
Each layer is positioned in the same area on the output document. The
exact position depends on the distance between the lower left corner of
ORIS PDF Tuner Version 4.4.8 User Manual 3-63
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com