ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Importing PDF and PostScript Files
‘Correct’ Tab
Note:
Note:
Using an option on the CHECK tab you can check whether such elements
occur in a document (see page 2-15).
Increase size of tints and image clipping paths
During normal operation this option should always be disabled.
When processing PDF files, enable this option if there are problems with
white gaps between tints or composed images. The program will then
slightly increase the tints and image clipping paths that are created internally
when the files are imported.
Increasing the size of tints may cause type to print slightly thicker, if the
fonts on the page have been converted to paths in the DTP program.
Convert RGB tints to CMYK
If this option is enabled, RGB colors of tints and gradients will be converted
to CMYK.
Ignore checksum mismatch of…
Use this option to specify what to do with PDF and PostScript files containing
erroneous Flate compressed data. If enabled, these files are imported
completely in spite of the compression error. If disabled, processing
will be terminated with an error message.
Repair faulty Illustrator gradients…
Enable this option to correct erroneous gradients created with Adobe
Illustrator. Note that any spot colors used in these gradients will be converted
to CMYK if this option is used.
Use Acrobat compatibility mode
If this option is enabled, the program will handle certain problems in the
same way as Acrobat 8 and later versions or as Acrobat 7 and earlier
versions, respectively. If this option is disabled, the problems will be handled
in the same way as Harlequin RIP.
This applies to the following problems:
• Undefined character codes
Eliminated by Acrobat, output as squares by Harlequin RIP.
ORIS PDF Tuner Version 4.4.8 User Manual 2-19
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com