ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating Standard Paths
Creating Polygons and Arcs
http://www.image2output.com
Creating Polygons and Arcs
Stars
1. Select PATHS | POLYGONS | STAR.
Define the center of the star by clicking on the layout or entering the
coordinate on the keyboard (direct input).
2. Define the radius of the inner circle, the radius of the outer circle and
then the number of points. Do one of the following:
• Click on the layout, move the mouse vertically until the value you
want is reached, then click again.
• Enter the value directly on the keyboard.
Polygon: Center And Point
How to create a polygon by specifying the center and a point on the outline:
1. Select PATHS | POLYGONS | POLYGON (CENTER).
2. Define the center and then the point on the outline.
To do so, click on the layout or enter the coordinates on the keyboard.
3. Specify the number of corners by doing one of the following:
• Click on the layout, move the mouse vertically until the desired
number of corners is reached, then click again.
• Enter the value directly on the keyboard.
Polygon: Side Length
How to create a polygon by specifying the length of a side and the number
of corners:
1. Select PATHS | POLYGONS | POLYGON (SIDE).
2. Create the two points which define the polygon’s side length.
To do so, click on the layout or enter the coordinates on the keyboard.
3. Specify the number of corners by doing one of the following:
• Click on the layout, move the mouse vertically until the desired
number of corners is reached, then click again.
• Enter the value directly on the keyboard.
7-10 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com