ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

http://www.image2output.com
Creating Tints and Gradients
Selecting Colors
When finished, select OK or click anywhere outside the dialog to close
the dialog.
Picking Colors from Layout or Image
You can pick a color from the layout or an image in order to apply it to
another layer or image:
1. Position the cursor on the image or layout
that contains the color you want to
pick up.
2. SHIFT-click.
The color located under the cursor is displayed
in the color selection box.
3. To close the dialog, select OK or click
anywhere outside the dialog.
Note:
In the COLOR SELECTION dialog, the color you have picked up is always
represented in the CMYK color space, even if the layer is a tint or gradient
whose color has been defined in another color space (e.g. RGB) or
if it is a spot color.
Defining Colors by Specifying Values
1. Select the color space to be used from the list.
For details on selecting spot colors refer to page 10-11.
2. Use the sliders to change the color values or type them into the input
boxes.
Note that the effect of a value input will not be visible until you click
into another input box or select OK to leave the dialog.
3. The new color is displayed in the color selection box. If you want to
store it, drag it to a palette box (see page 10-11).
4. Click OK to leave the dialog.
Note: • On grayscale images you can only select the GRAYSCALE color
space to prevent an unintentional conversion into a color image.
• The color displayed in the selection field may change slightly when
you change the color space from CMYK to RGB, HSB or Lab. This is
ORIS PDF Tuner Version 4.4.8 User Manual 10-9
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com