ORIS PDF Tuner Version 4.4.8 User Manual - image2output - Support

Creating ‘Smooth Text’
Smooth Text Adjusting to Single Closed Outline
If MODE is set to BASELINE:
http://www.image2output.com
• The CLOCKWISE setting will cause
the text to be set outside the outline,
i.e. in clockwise setting direction.
• The COUNTER-CLockWise setting will
cause the text to be set inside the
outline, i.e. in counter-clockwise setting
direction.
If MODE is set to CONTOUR:
The text is set within the outline with both settings.
• With the CLOCKWISE setting the text
is set in clockwise direction, which
causes the text to turn upside down.
• With the COUNTER-CLockWise setting
the text is set in counter-clockwise
direction. The text is represented
normally.
Note:
Do not use the SETTING DIRECTion 2 option, as it usually does not produce
any reasonable results when working with a single closed outline.
Baseline
Use this option to define the position of the text relative to the path. The
outline is treated just like a line in this case. The MODE option must be
set to BASELINE. If set to CONTOUR, the BASELINE option has no effect.
Bottom
With this setting the bottom of the
text touches the baseline, i.e., the
text is placed outside the outline.
13-10 CGS GmbH Hainburg, Germany 11/03/2010
Image2Output Limited Unit 19 IO Centre Hearle Way Hatfield Business Park Hatfield Herts AL10 9EW
Tel: +44 (0)1707 282 710 Fax: +44 (0)1707 269 764 sales@image2output.com