STM32F101xx, STM32F102xx, STM32F103xx, STM32F105xx and ...

RM0008
Flexible static memory controller (FSMC)
Bits 15:8 DATAST: Data-phase duration
These bits are written by software to define the duration of the data phase (refer to
Figure 162 to Figure 172), used in SRAMs, ROMs and asynchronous multiplexed NOR Flash
accesses:
0000 0000: Reserved
0000 0001: DATAST phase duration = 2 × HCLK clock cycles
0000 0010: DATAST phase duration = 3 × HCLK clock cycles
...
1111 1111: DATAST phase duration = 256 × HCLK clock cycles (default value after reset)
For each memory type and access mode data-phase duration, please refer to the respective
figure (Figure 162 to Figure 172).
Example: Mode1, read access, DATAST=1: Data-phase duration= DATAST+3 = 4 HCLK
clock cycles.
Bits 7:4 ADDHLD: Address-hold phase duration
These bits are written by software to define the duration of the address hold phase (refer to
Figure 170 to Figure 172), used in mode D and multiplexed accesses:
0000: Reserved
0001: ADDHLD phase duration = 2 × HCLK clock cycle
0010: ADDHLD phase duration = 3 × HCLK clock cycle
...
1111: ADDHLD phase duration = 16 × HCLK clock cycles (default value after reset)
For each access mode address-hold phase duration, please refer to the respective figure
(Figure 170 to Figure 172).
Example: ModeD, read access, ADDHLD=1: Address-hold phase duration = ADDHLD + 1 =2
HCLK clock cycles.
Note: In synchronous accesses, this value is not used, the address hold phase is always 1
memory clock period duration.
Bits 3:0 ADDSET: Address setup phase duration
These bits are written by software to define the duration of the address setup phase (refer to
Figure 162 to Figure 172), used in SRAMs, ROMs and asynchronous NOR Flash:
0000: ADDSET phase duration = 1 × HCLK clock cycle
...
1111: ADDSET phase duration = 16 × HCLK clock cycles (default value after reset)
For each access mode address setup phase duration, please refer to the respective figure
(refer to Figure 162 to Figure 172).
Example: Mode2, read access, ADDSET=1: Address setup phase duration = ADDSET + 1 =
2 HCLK clock cycles.
Note: In synchronous accesses, this value is not used, the address hold phase is always 1
memory clock period duration.
Note:
PSRAMs (CRAMs) have a variable latency due to internal refresh. Therefore these
memories issue the NWAIT signal during the whole latency phase to prolong the latency as
needed.
With PSRAMs (CRAMs) the filed DATLAT must be set to 0, so that the FSMC exits its
latency phase soon and starts sampling NWAIT from memory, then starts to read or write
when the memory is ready.
This method can be used also with the latest generation of synchronous Flash memories
that issue the NWAIT signal, unlike older Flash memories (check the datasheet of the
specific Flash memory being used).
Doc ID 13902 Rev 9 439/995