STM32F101xx, STM32F102xx, STM32F103xx, STM32F105xx and ...

USB on-the-go full-speed (OTG_FS)
RM0008
same time. If more than 8 transfer requests are pending from the application, the host
controller driver (HCD) must re-allocate channels when they become available from
previous duty, that is, after receiving the transfer completed and channel halted interrupts.
Each host channel can be configured to support in/out and any type of periodic/nonperiodic
transaction. Each host channel makes us of proper control (HCCHARx), transfer
configuration (HCTSIZx) and status/interrupt (HCINTx) registers with associated mask
(HCINTMSKx) registers.
Host channel control
●
The following host channel controls are available to the application through the host
channel-x characteristics register (HCCHARx):
– channel enable/disable
– program the FS/LS speed of target USB peripheral
– program the address of target USB peripheral
– program the endpoint number of target USB peripheral
– program the transfer IN/OUT direction
– program the USB transfer type (control, bulk, interrupt, isochronous)
– program the maximum packet size (MPS)
– program the periodic transfer to be executed during odd/even frames
Host channel transfer
The host channel transfer size registers (HCTSIZx) allow the application to program the
transfer size parameters, and read the transfer status. Programming must be done before
setting the channel enable bit in the host channel characteristics register. Once the endpoint
is enabled the packet count field is read-only as the OTG FS core updates it according to the
current transfer status.
● The following transfer parameters can be programmed:
– transfer size in bytes
– number of packets constituting the overall transfer size
– initial data PID
Host channel status/interrupt
The host channel-x interrupt register (HCINTx) indicates the status of an endpoint with
respect to USB- and AHB-related events. The application must read these register when the
host channels interrupt bit in the core interrupt register (HCINT bit in OTG_FS_GINTSTS) is
set. Before the application can read these registers, it must first read the host all channels
interrupt (HCAINT) register to get the exact channel number for the host channel-x interrupt
register. The application must clear the appropriate bit in this register to clear the
706/995 Doc ID 13902 Rev 9