STM32F101xx, STM32F102xx, STM32F103xx, STM32F105xx and ...

RM0008
USB on-the-go full-speed (OTG_FS)
OTG_FS host channel-x interrupt register (OTG_FS_HCINTx) (x = 0..7, where
x = Channel_number)
Address offset: 0x508 + (Channel_number × 0x20)
Reset value: 0x0000 0000
This register indicates the status of a channel with respect to USB- and AHB-related events.
It is shown in Figure 268. The application must read this register when the Host channels
interrupt bit in the Core interrupt register (HCINT bit in OTG_FS_GINTSTS) is set. Before
the application can read this register, it must first read the Host all channels interrupt
(OTG_FS_HAINT) register to get the exact channel number for the Host channel-x interrupt
register. The application must clear the appropriate bit in this register to clear the
corresponding bits in the OTG_FS_HAINT and OTG_FS_GINTSTS registers.
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
Reserved
DTERR
rc_
w1
FRMOR
rc_
w1
BBERR
rc_
w1
TXERR
Reserved
rc_
w1
ACK
rc_
w1
NAK
rc_
w1
STALL
Reserved
rc_
w1
CHH
rc_
w1
XFRC
rc_
w1
Bits 31:11 Reserved
Bit 10 DTERR: Data toggle error
Bit 9 FRMOR: Frame overrun
Bit 8 BBERR: Babble error
Bit 7 TXERR: Transaction error
Indicates one of the following errors occurred on the USB.
CRC check failure
Timeout
Bit stuff error
False EOP
Bit 6 Reserved
Bit 5 ACK: ACK response received/transmitted interrupt
Bit 4 NAK: NAK response received interrupt
Bit 3 STALL: STALL response received interrupt
Bit 2 Reserved
Bit 1 CHH: Channel halted
Indicates the transfer completed abnormally either because of any USB transaction error or in
response to disable request by the application.
Bit 0 XFRC: Transfer completed
Transfer completed normally without any errors.
Doc ID 13902 Rev 9 751/995