RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom RMX 1500/2000/4000 Administrator’s Guide
The New Entry Queue dialog box is displayed.
3 Define the Entry Queue parameters as for a standard Entry Queue.
For more information about Entry Queue parameters, see the RMX 1500/2000
Administrator’s Guide, “Entry Queues” on page 6-1.
4 In the Cascade field, select Master or Slave depending on the Master/Slave relationship.
— Set this field to Master if:
• The Entry Queue is defined on the MCU on level 1 and the dialing is done
from level 2 to level 1.
• The Entry Queue is defined on the MCU on level 2 and the dialing is done
from level 3 to level 2.
— Set this field to Slave if the Entry Queue is defined on the MCU on level 2 (Slave)
and the dialing is done from MCU level 1 to level 2.
5 Click OK.
Cascade-enabled Entry Queues should not be used to connect standard participants to
conferences.
Creating the Cascaded Conferences
The table below lists the line rates that should be used when defining the conference Profiles
for cascaded conferences on the RMX on both Level 1 and Level 2. The video settings will be
automatically selected by the system, however, if HD Video Switching is used, it must be
selected in the conference Profiles.
Table 4-5 Recommended Conference Line Rates for Cascaded Conferences
Topology Video Session Mode Conference Line Rate
RMX
RMX
CP-HD 1.5Mb/s, 1Mb/s, 2Mb/s
CP-CIF 768Kb/s, 2Mb/s
4-32 Polycom, Inc.