RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table B-1 Alarms (Continued)
Alarm Code Alarm Description
Appendix B-Alarms and Faults
Low Processing Memory Low Processing Memory:
Process is approaching memory utilization limit: [Memory Utilization Percent]
Low system Memory Low system Memory:
The system exceeded 80% of memory usage.
Management Network not configured
MCU is not configured for AVF
gatekeeper mode
MCU reset The MCU was reset automatically or by the user.
MCU Reset to enable Diagnostics mode
Missing Central Signaling configuration
MPL startup failure. Authentication not
received.
MPL startup failure. Management
Network configuration not received.
MCU reset:
Reset cause: [reset source].
Music file error The music file played during the connection to the conference cannot be
accessed.
No clock source The system could not use any of the connected ISDN spans as clock source
No default ISDN/PSTN Network Service
defined in ISDN/PSTN Network Services
list
No default IVR Service in IVR Services
list
No default IVR Service in IVR Services list: Ensure that one conference IVR
Service and one EQ IVR Service are set as default.
No IP Network Services defined IP Network Service parameters missing.
No ISDN/PSTN Network Services defined No ISDN/PSTN Network Services were defined or no default ISDN/PSTN
Network was defined.
No License for ISDN/PSTN. Please
activate the RTM ISDN card through
Polycom website
No response from Central Signaling No connection with central signaling.
No response from RTM ISDN card
No usable unit for audio controller;
NTP synchronization failure The system failed to synchronize the MCU clock with the NTP clock
Polycom default User exists. For security
reasons, it is recommended to delete this
User and create your own User.
Polycom, Inc. B-7