RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Chapter 15-Network Services
Figure 15-4 shows the cables connected to the RMX 4000 rear panel, when one RTM ISDN
and three RTM LAN cards are installed providing IP and ISDN connectivity. The RTM
ISDN card can be used for both ISDN and IP calls and only one IP network Service is
associated with each RTM LAN card.
Figure 15-4RMX 4000 Rear Panel with LAN and PRI cables
In this case, up to four different IP Network Services can be defined - one for each RTM
LAN/RTM ISDN cards installed in the system.
If two LAN ports per each installed RTM LAN card are used, up to three additional
Network Services can be defined, bringing it to a total of up to 7 IP Network Services.
Several cards can be assigned to the same IP Network Service. The definition of the network
services attached to the RMX unit and which cards are assigned to each network service is
defined in the IP Network Service.
RMX 2000 Multiple Services Configuration
Connecting the cables to the RTM IP:
The following cables are connected to the RTM IP on the rear panel of the RMX2000:
Table 15-29 LAN Connections to the RTM IP
RTM IP Port Description
LAN 1 –
LAN cable (Media & PRI cable
Signaling) Network 4 LAN cable
(Media & Signaling)
Network 3
LAN cable
(Media & Signaling)
Network 2
Management
Network
LAN 2 Management
Shelf Management
LAN cable
(Media & Signaling)
Network 1
Polycom, Inc. 15-51