RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table 21-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description
APACHE_KEEP_ALIVE_TIM
EOUT
AVOID_VIDEO_LOOP_BAC
K_IN_CASCADE
BONDING_DIALING_METH
OD
(ISDN)
BONDING_GROUP_DELAY
(ISDN)
BONDING_NUM_CHANNEL
S_IN_GROUP
(ISDN)
Chapter 21-System Configuration Flags
If the connection is idle for longer than the number of seconds
specified by this flag, the connection to the RMX is
terminated.
Value: 0 - 999
Default: 120
Default (ULTRA_SECURE_MODE=YES): 15
Note: A value of 0 results in an unlimited keep-alive duration.
This value should never be used in Ultra Secure Mode.
When set to YES the current speaker’s image is not sent back
through the participant link in cascaded conferences with
conference layouts other than 1x1.
Default: YES
Range: YES / NO
When set to:
• SEQUENTIAL
The MCU initiates channel connections sequentially until it
reaches the number of channels defined by the
BONDING_NUM_CHANNELS_IN
_GROUP flag.
When a channel is connected, dialing begins for the next
channel in the group.
• BY_TIMERS
The MCU initiates channel connections sequentially using
the values of the BONDING_CHANNEL _DELAY and
BONDING_GROUP_DELAY flags.
The first group of channels is dialed, using the
BONDING_CHANNEL_DELAY between dialing attempts
for each channel in the group.
The RMX then implements the
BONDING_GROUP_DELAY, before dialing the first
channel of the next group.
Default: SEQUENTIAL
When connecting several bonding groups, this is the delay
(number of 1/100 seconds) preceding the first dialing attempt
to connect the next bonding group.
Default: 500
The number of channels in the bonding group to be
connected before dialing the next sequential channel.
Default: 50
BURN_BIOS Although, not recommended, setting this flag’s value to NO
will prevent BIOS upgrade.
Default: YES.
Polycom, Inc. 21-17