RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Appendix G-Configuring Direct Connections to RMX
4 In the Local Area Connection Properties dialog box, select Internet Protocol [TCP/IP] >
Properties.
5 In the Internet Protocol (TCP/IP) Properties dialog box, select Use the following IP
address.
6 Enter the IP address, Subnet mask and Default gateway for the workstation.
The workstation’s IP address should be in the same network neighborhood as the
RMX’s Control Unit IP address.
Example: IP address – near 192.168.1.nn
None of the reserved IP addresses listed in Table G-1 should be used for the IP Address.
The Subnet mask and Default gateway addresses should be the same as those for the
RMX’s Management Network.
The addresses needed for connection to either the RMX’s Default Management Network
or Alternate Management Network are listed in Table G-1.
For more information about connecting to the Alternate Management Network, see
"Connecting to the Alternate Management Network” on page G-6.
Polycom, Inc. G-3