RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom RMX 1500/2000/4000 Administrator’s Guide
Manually Adding Flags to the CS_MODULE_PARAMETERS Tab
Using the procedure to manually add flags to the System Configuration, the following flags
can be manually added to the CS_MODULE_PARAMETERS tab:
Deleting a Flag
Auto Layout Configuration
Table 21-3 Manually Added Flags - CS_MODULE_PARAMETERS Tab
Flag Description
CS_ENABLE_EPC Add this flag with the value YES (default value is NO) to enable endpoints
that support People+Content and require a different signaling (for example,
FX endpoints) to receive Content.
H245_TUNNELING For use in the Avaya Environment.
In the Avaya Environment, set the flag to YES to ensure that H.245 is
tunneled through H.225. Both H.245 and H.225 will use the same signaling
port.
Default: NO.
H323_RAS_IPV6 If the RMX is configured for IPv4 & IPv6 addressing, RAS (Registration,
Admission, and Status) messages are sent in both IPv4 and IPv6 format. If
the gatekeeper cannot operate in IPv6 addressing mode, registration fails
and endpoints cannot connect using the RMX prefix.
In such cases this System Flag should be set to NO.
Default: YES
MS_UPDATE_CON
TACT_REMOVE
QOS_IP_SIGNALIN
G
When the flag value is set to:
• YES - The Contact Header is removed from the UPDATE message that
is sent periodically to the endpoints.
This is required when the SIP Server Type field of the IP Network
Service is set as Microsoft. Removal of the Contact Header from the
UPDATE message is required specifically by OCS R2.
• NO - The Contact Header is included in the UPDATE message. This is
the system behavior when the SIP Server Type is set as Generic.
This is required when the RMX is configured to accept calls from both
Microsoft LYNC and Cisco CUCM as CUCM requires the Contact
Header.
Used to select the priority of IP packets when DiffServ is the is the selected
method for packet priority encoding.
Range: 0x##
Default: 0x00
To delete a flag:
1 In the System Flags dialog box, select the flag to delete and click the Delete Flag button.
2 In the confirmation message box, click Yes to confirm.
3 Click OK to close the System Flags dialog box.
The Auto Layout option lets the RMX automatically select the conference video layout based
on the number of participants currently connected to the conference. You can modify the
21-30 Polycom, Inc.