RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Chapter 15-Network Services
Conferencing related definitions such as environment (H.323 or SIP) are also defined in this
service.
Most of the Default IP Service is configured by the Fast Configuration Wizard, which runs
automatically should the following occur:
• First time power-up.
• Deletion of the Default IP Service, followed by a system reset.
For more information, see the RMX 1500/2000/4000 Getting Started Guide, "Procedure 1: Firsttime
Power-up” on page 2-24.
Changes made to any of these parameters only take effect when the RMX unit is reset. An Active
Alarm is created when changes made to the system have not yet been implemented and the MCU
must be reset.
Modifying the Management Network
The Management Network parameters need to be modified if you want to:
• Connect directly to the RMX from a workstation
• Modify routes
• Modify DNS information
To view or modify the Management Network Service:
1 In the RMX Management pane, click the IP Network Services ( ) button.
2 In the IP Network Services list pane, double-click the Management Network (
The Management Network Properties - IP dialog box opens.
) entry.
Polycom, Inc. 15-3