RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom RMX 1500/2000/4000 Administrator’s Guide
Table 21-2 Manually Added System Flags – MCMS_PARAMETERS (Continued)
Flag Description
CASCADE_LINK_PLAY_TO
NE_ON_CONNECTION
When set to YES, the RMX plays a tone when a cascading
link between conferences is established. The tone is played in
both conferences.
This tone is not played when the cascading link disconnects
from the conferences.
The tone used to notify that the cascading link connection has
been established cannot be customized.
Default value: NO.
The tone volume is controlled by the same flag as the IVR
messages and tones: IVR_MESSAGE_VOLUME.
CAC_ENABLE When set to YES, enables the Call Admission Control
implementation in the RMX.
Default: NO (CAC is disabled)
CONF_GATHERING_DURAT
ION_SECONDS
CP_REGARD_TO_INCOMIN
G_SETUP_RATE
DELAY_BETWEEN_H320_D
IAL_OUT_PARTY
(ISDN)
DISABLE_GW_OVERLAY_I
NDICATION
DISABLE_WIDE_RES_TO_S
IP_DIAL_OUT
The value of this System Flag sets the duration of the
Gathering Phase in seconds. The Gathering Phase duration
of the conference is measured from the scheduled start time
of the conference.
Range: 0 - 3600
Default: 180
For more information see "Video Preview” on page 3-19.
For use in the Avaya Environment.
If set to YES, the RMX calculates the line rate for incoming
calls in CP conferences, according to the line rate which is
declared by the endpoint in the H.225 setup message.
If set to NO, the rate is calculated according to the conference
line rate regardless of the rate in the H.225 setup message.
Default: YES.
The delay in milliseconds that the MCU waits when
connecting dial out ISDN and PSTN participants.
Default: 1000
When set to NO (default), displays progress indication during
the connection phase of a gateway call.
Set the value to YES to hide the connection indications
displayed on the participant’s screen during the connection
phase of a gateway call.
When set to NO (default), the RMX sends wide screen
resolution to dial-out SIP endpoints. Endpoint types that do
not support wide screen resolutions are automatically
identified by the RMX according to their product type and
version and will not receive the wide resolution even if the flag
is set to YES.
When manually added and set to YES, the RMX does not
send wide screen.
Default: NO.
21-18 Polycom, Inc.