RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom RMX 1500/2000/4000 Administrator’s Guide
First Time Installation and Configuration
First Time Installation and Configuration of the RMX 1500/2000/4000 consists of the following
procedures:
1 Preparations:
— Gather Network Equipment and Address Information - get the information needed
for integrating the RMX into the local network for each of the networks that will be
connected to the RMX unit. For a list of required address, see the RMX 1500/2000/
4000 Getting Started Guide, "Gather Network Equipment and Address Information” on
page 2-2.
2 Hardware Installation and Setup
— Mount the RMX in a rack. For more details see the RMX 1500/2000/4000 Getting
Started Guide, "Hardware Installation and Setup” on page 2-9.
— Connect the necessary cables. For details, see RMX 1500/2000/4000 Getting Started
Guide, "Hardware Installation and Setup” on page 2-9.
3 First Entry Power-up and Configuration
— Power up the RMX. For more details see the RMX 1500/2000/4000 Getting Started
Guide, "Procedure 1: First-time Power-up” on page 2-24.
— Register the RMX. For more details see the RMX 1500/2000/4000 Getting Started
Guide, "Procedure 2: Product Registration” on page 2-25.
— Connect to the RMX. For more details see the RMX 1500/2000/4000 Getting Started
Guide, "Procedure 3: Connection to MCU” on page 2-25.
— Configure the Default IP Network Service using the information for one of the
networks connected a media card installed in the system. For more details see the
RMX 1500/2000/4000 Getting Started Guide, "Procedure 4: Modifying the Default IP
Service and ISDN/PSTN Network Service Settings” on page 2-27.
— Optional. Configure the ISDN/PSTN Network Service. For more details see the RMX
1500/2000/4000 Getting Started Guide, "ISDN/PSTN Services” on page 2-4.
4 Modify the required System Flag to enable Multiple Services and reset the MCU.
5 Add the required IP Network Services to accommodate the networks connected to the
RMX unit.
6 Select a Network Service to act as default for dial out and gateway calls for which the
Network Service was not selected.
7 Place several calls and run conferences to ensure that the system is configured
correctly."Gather Network Equipment and Address Information” on page 2-2
Upgrading to Multiple Services
1 Gather Network Equipment and Address Information for each of the networks that will
be connected to the RMX unit. For a list of required address, see RMX 1500/2000/4000
Getting Started Guide, "Gather Network Equipment and Address Information” on page 2-2.
2 Upgrade to the new version and install the activation key that contains the Multiple
Services license as described in RMX 1500/2000/4000 Release Notes.
3 Place several calls and run conferences to ensure that the system upgrade was
completed successfully.
15-48 Polycom, Inc.