RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom RMX 1500/2000/4000 Administrator’s Guide
Table B-1 Alarms (Continued)
Alarm Code Alarm Description
Port configuration was modified
Power off
Process idle Process idle:
Process did not finish before deadline.
Process terminated Process terminated:
[Process name] terminated.
Product activation failure
Product Type mismatch. System is
restarting.
Recording device has disconnected
unexpectedly
The user is alerted to a mismatch between the product type that is stored in
MCU software and the product type received from another system component.
In such a case the system is automatically restarted.
Red Alarm When a certain timeout will be reached (after startup), MCMS will go over the
configured Spans. A configured Span that is related to nonexistent card – will
produce a 'RED_ALARM' Alert. Similarly on HotSwap: if an RTM card (or an
MPM that has an RTM extension) is removed, MCMS will go over the
configured Spans. A configured Span that is related to the removed card – will
produce a 'RED_ALARM' Alert.
Resource process did not receive the
Meeting Room list during startup.
Resource process failed to request the
Meeting Room list during startup.
Without the Meeting Rooms list, the system cannot allocate the appropriate
dial numbers, Conference ID etc. and therefore cannot run conferences
Without the Meeting Rooms list, the system cannot allocate the appropriate
dial numbers, Conference ID etc. and therefore cannot run conferences
Restore Failed Restoring the system configuration has failed as the system could not locate
the configuration file in the selected path, or could not open the file.
Restore Succeeded Restoring the system configuration has succeeded. Reset the MCU.
Restoring Factory Defaults. Default
system settings will be restored once
Reset is completed
RTM ISDN card not found RTM ISDN card is missing.
Default system settings will be restored once Reset is completed.
RTM ISDN card startup procedure error The RTM ISDN card cannot complete its startup procedure (usually after
system reset)
Secured SIP communication failed
Security mode failed. Certificate has
expired.
Security mode failed. Certificate host
name does not match the RMX host
name.
Security mode failed. Certificate is about
to expire.
B-8 Polycom, Inc.