RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table 21-1 System Flags – MCMS_PARAMETERS (Continued)
Flag Description
PASSWORD_HISTORY_SIZ
E
RESTRICT_CONTENT_BRO
ADCAST_TO_LECTURER
Chapter 21-System Configuration Flags
The number of passwords that are recorded to prevent users
from re-using their previous passwords.
Values are between 0 and 16.
0 (standard default) - the rule is not enforced, however this
rule cannot be disabled when the RMX is in Ultra Secure
Mode.
In Ultra Secure Mode, at least 10 passwords (default) and up
to 16 passwords must be retained.
For more details, see "Implementing Password Re-Use /
History Rules” on page 14-11.
If set to YES, only the conference lecturer may send content
to the conference.
If set to NO, any conference participant can send content.
Default: YES
RMX2000_RTM_LAN This flag is used after installation on and RTM-LAN card to
activate the card. The flag must be set to YES. (RMX2000
only.)
RRQ_WITHOUT_GRQ To enable registration, some gatekeepers require sending
first RRQ and not GRQ.
Set flag to YES, if this behavior is required by the gatekeeper
in your environment.
Default: NO.
GRQ (Gatekeeper Request) - Gatekeeper discovery is the process
an endpoint uses to determine which gatekeeper to register with.
RRQ - registration request sent to the gatekeeper.
SEPARATE_MANAGEMENT
_NETWORK
SESSION_TIMEOUT_IN_MI
NUTES
Enables/disables the Network Separation. Can only be
disabled in the Ultra Secure Mode
(ULTRA_SECURE_MODE=YES).
Default: NO.
If there is no input from the user or if the connection is idle for
longer than the number of minutes specified by this flag, the
connection to the RMX is terminated.
Value: 0-99
0 - Session Timeout is disabled, however this feature cannot
be disabled when the RMX is in Ultra Secure Mode.
Default: 0
Default (ULTRA_SECURE_MODE=YES): 10
Polycom, Inc. 21-13