RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Chapter 20-RMX Administration and Utilities
15 To specifically define one or more valid terminals, ensure that the Accept SNMP Packets
from any Host option is cleared and then click the Add button.
The Accepted Host IP Address dialog box opens.
16 Enter the IP Address of the Manager terminal from which valid queries may be sent to
the MCU, and then click OK.
Click the Add button to define additional IP Addresses.
The IP Address or Addresses are displayed in the Accept SNMP Packets from These Hosts
box.
Queries sent from terminals not listed in the Accept SNMP Packets from These Hosts box are
regarded as a violation of the MCU security, and if the Send Authentication Trap check box is
selected, an appropriate message will be sent to all the terminals listed in the SNMP Properties –
Traps dialog box.
17 In the RMX - SNMP Properties - Security dialog box, click OK.
Polycom, Inc. 20-35