RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom RMX 1500/2000/4000 Administrator’s Guide
For Example: 1002##12001##1234
Cascade-enabled
EQ ID
Method B (Using a gatekeeper):
Destination
Conference ID
In the Alias Name field, enter the Prefix of MCU B, EQ ID, Destination Conference ID,
and Password, as follows:
MCU Prefix EQ ID##Conference ID##Password (Password is optional)
For Example: 9251002##12001##1234
MCU Prefix as
registered in the
gatekeeper
Cascade-enabled
EQ ID
Password (optional)
Conference ID
Password (optional)
5 Click the Advanced tab and in the Node Type field, select Terminal.
6 Click OK.
Setting the Flags on the RMX
When running conferences in mixed environment (RMX and MGC) there may be small
differences between the line rates each MCU is sending. In the RMX 2000/4000, several flags
must be set to ensure that these differences will not cause the cascaded link to connect as
Secondary and that Content flows correctly between the cascaded conferences. This
procedure is performed once per RMX.
1 In the RMX Web Client menu, click Setup>System Configuration.
2 In the System Flags dialog box, add the following new flags and values:
— MIX_LINK_ENVIRONMENT=YES
Setting this flag to YES will adjust the line rate of HD Video Switching conferences
run on the RMX 2000/4000 from 1920Kbps to 17897Kbps to match the actual rate of
4-38 Polycom, Inc.