19.08.2013 Views

RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Appendix J-<strong>Polycom</strong> Open Collaboration Network (POCN)<br />

Table J-1 lists components and versions of the <strong>RMX</strong> and Cisco Telepresence Systems (CTS)<br />

Integration Solution Architecture.<br />

Table J-1 Solution Architecture Components<br />

Component <strong>Version</strong> Description<br />

CISCO Equipment<br />

CUCM 8.5 Cisco Unified Communication Manager:<br />

CUCM must be configured to:<br />

• Route calls to DMA (if present).<br />

• Route all H.323 calls to the gatekeeper, which can be<br />

either CMA or IOS.<br />

IOS 15.x Cisco Internetwork Operating System - Gatekeeper<br />

Endpoints (CTS) 1.7 Telephony, desktop and room systems.<br />

• CTS endpoints must register to CUCM.<br />

<strong>Polycom</strong> Equipment<br />

DMA 7000 4.0 <strong>Polycom</strong> Distributed Media Application<br />

• DMA is an optional component but is essential if Content<br />

sharing is to be enabled.<br />

• All SIP endpoints register to DMA as a SIP Proxy.<br />

• DMA should be configured to route SIP calls (with CTS<br />

destination) to CUCM. If DMA is not present in the<br />

solution architecture, SIP endpoints must register to<br />

CUCM as gatekeeper.<br />

• DMA must be configured with a VMR (Virtual Meeting<br />

Room). Incoming calls are then routed to the <strong>RMX</strong>.<br />

<strong>RMX</strong> 7.6.x MCU:<br />

• Functions as the network bridge for multipoint calls<br />

between H.323, SIP and TIP endpoints.<br />

• The <strong>RMX</strong> can be interfaced to CUCM using a SIP trunk,<br />

enabling CTS to join multipoint calls on <strong>RMX</strong>. Signaling<br />

goes through the CUCM while the media in TIP format<br />

goes directly between the CTS and <strong>RMX</strong>.<br />

• The <strong>RMX</strong> must be configured to route outbound SIP calls<br />

to DMA.<br />

• The H.323 Network Service of the <strong>RMX</strong> should register<br />

it's dial prefix with the CMA gatekeeper.<br />

• When DMA is not used an Ad-hoc Entry Queue,<br />

designated as Transit Entry Queue, must be pre-defined<br />

on the <strong>RMX</strong>.<br />

MLA 3.0.3 Multipoint Layout Application<br />

Required for managing multi-screen endpoint layouts for<br />

Cisco CTS 3XXX, <strong>Polycom</strong> TPX, RPX or OTX systems.<br />

CMA 5.5 <strong>Polycom</strong> Converged Management Application - Gatekeeper<br />

• The gatekeeper must route calls to <strong>RMX</strong> based on the<br />

<strong>RMX</strong> prefix registration on the gatekeeper.<br />

<strong>Polycom</strong>, Inc. J-3

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!