RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

RMX Configuration
RMX 1500 Multiple Services Configuration
Chapter 15-Network Services
Connecting the cables to the RTM IP 1500:
The following cables are connected to the RTM IP on the rear panel of the RMX 1500:
Table 15-31 LAN Connections to the RTM IP
RTM IP Port Description
LAN 1 Media and signaling - additional (second) Network Service
LAN 2 Media and signaling - existing (first) Network Service
MNG –
MNG B Management
Shelf Shelf Management
LAN 3 –
LAN 4 –
Modem Modem
Once the network cables are connected to the RMX unit, you can modify the default IP
Network Service and add additional Network Services.
System Flags and License Settings
The MULTIPLE_SERVICES System Flag determines whether the Multiple Services option
will be activated once the appropriate license is installed. Possible Values: YES / NO
Default: NO
This flag must be manually added to the system configuration and set to YES to enable this
option. For more information see "Manually Adding and Deleting System Flags” on page 21-16.
If the MULTIPLE_SERVICES System Flag is set to YES and no RTM ISDN or RTM LAN card is
installed in the RMX 2000, an Active Alarm is displayed.
If the values or either of the MULTIPLE_SERVICES or V35_ULTRA_SECURED_SUPPORT System
Flags are changed from YES to NO, the defined IP Network Services are not displayed in the IP
Network Services list pane: they are, however, saved in the system.
If either of the flag values are changed back to YES, the saved defined IP Network Services will be
displayed.
Polycom, Inc. 15-53