RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

4 Define the following Advanced parameters:
ISDN/PSTN
Participant
Table 7-3 New Participant – Advanced Properties
Field Description
Video Bit Rate / Auto
(IP Only)
IP/SIP
Participant
Chapter 7-Address Book
The Auto check box is automatically selected to use the Line Rate
defined for the conference.
Note: This check box cannot be cleared when defining a new
participant during an ongoing conference.
To specify the video rate for the endpoint, clear this check box and
then select the required video rate.
Video Protocol Select the video compression standard that will be forced by the MCU
on the endpoint when connecting to the conference: H.261, H.263,
H.264 or RTV.
Select Auto to let the MCU select the video protocol according to the
endpoint’s capabilities.
Resolution The Auto check box is automatically selected to use the Resolution
defined for the conference.
To specify the Resolution for the participant, select the required
resolution from the drop-down menu.
Broadcasting Volume
+ Listening Volume
To adjust the volume the participant broadcasts to the conference or
the volume the participant hears the conference, move the slider;
each unit represents an increase or decrease of 3 dB (decibel). The
volume scale is from 1 to 10, where 1 is the weakest and 10 is the
strongest. The default connection value is 5.
Polycom, Inc. 7-7