19.08.2013 Views

RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

SHOW MORE
SHOW LESS

You also want an ePaper? Increase the reach of your titles

YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.

Chapter 15-Network Services<br />

4 Modify the required System Flag to enable Multiple Services, DO NOT reset the MCU<br />

yet.<br />

5 Connect the additional network cables to the <strong>RMX</strong> and change existing connections to<br />

match the required configuration as described in the “<strong>RMX</strong> Hardware Installation” on<br />

page 50.<br />

At this point, the Management Network can be modified to match the required local<br />

network settings.<br />

If the <strong>RMX</strong> <strong>2000</strong> you are upgrading does not include RTM ISDN or RTM LAN cards, you must install<br />

at least one RTM LAN card to enable the definition of multiple Network Services. If no RTM ISDN or<br />

RTM LAN cards are installed, the <strong>RMX</strong> <strong>2000</strong> works in a single Network Service mode and an alarm<br />

is issued by the system. For more details about the installation of RTM LAN cards, see the <strong>RMX</strong><br />

<strong>2000</strong> Hardware <strong>Guide</strong>.<br />

6 Reset the MCU.<br />

7 Connect to the MCU and Add the required IP Network Services to accommodate the<br />

networks connected to the <strong>RMX</strong> unit.<br />

8 Select a Network Service to act as default for dial out and gateway calls for which the<br />

Network Service was not selected.<br />

9 Place several calls and run conferences to ensure that the system is configured correctly.<br />

Gather Network Equipment and Address Information - IP Network Services<br />

Required Information<br />

It is important that before connecting multiple networks and implementing Multiple<br />

Services in the <strong>RMX</strong>, that you obtain the information needed to complete the IP Network<br />

Service configuration for each connected network from your network administrator.<br />

Table 15-26 Network Equipment and Address Information per IP Network Service<br />

Parameter Local Network Settings Note<br />

Signaling Host IP address<br />

Media Board IP address<br />

(MPM 1)<br />

Media Board IP address<br />

(MPM 2)<br />

<strong>RMX</strong> <strong>2000</strong>/4000 only<br />

Media Board IP address<br />

(MPM 3)<br />

<strong>RMX</strong> 4000 only<br />

Media Board IP address<br />

(MPM 4)<br />

<strong>RMX</strong> 4000 only<br />

Gatekeeper IP address<br />

(optional)<br />

If more than one media card is<br />

associated with this Network<br />

Service<br />

If more than one media card is<br />

associated with this Network<br />

Service<br />

If more than one media card is<br />

associated with this Network<br />

Service<br />

<strong>Polycom</strong>, Inc. 15-49

Hooray! Your file is uploaded and ready to be published.

Saved successfully!

Ooh no, something went wrong!