RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Chapter 22-RMX Hardware Monitoring
The logged events can be saved to a *.xls file by clicking the Save Event Log button. It is
not possible to save individual or multiple selected events; the entire log file must be
saved.
Table 22-4 MCU Properties - Event Log
Column Description
Record ID The recorded ID number of the logged event.
Time Stamp Lists the date and time that the event occurred.
Type Displays the type of event recorded in the log.
Sensor Number The number of the LED sensor on the RMX unit.
Sensor Description Describes which sensor the event is being logged.
Status The sensor’s active status.
Ipmb Address(hex) Contains all the internal IPMI network addresses on the IPMB bus,
i.e. 0x20 (Switch), 0x86 (MFA), etc...
3 Click the Active Alarms tab to view alarms related to the RMX, i.e. temperatures and
main power sensors.
The Active Alarms dialog box displays fields that relate to faults and errors detected on
the RMX by sensors. The Active Alarms dialog box is divided into two sections: HW
Alarm List and SW Alarm List.
Each section’s alarm list can be saved as a *.xls file by clicking the Save HW Alarm List
and Save SW Alarm List buttons respectively. Each alarm list color codes the severity
of the alarm; Critical (RED), Major (ORANGE) and Normal (GREEN).
If you connected to the Hardware Monitoring via the Shelf Management server, the SW Alarm List
section will not be displayed.
Polycom, Inc. 22-5