RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table 20-8 System Information (Continued)
Field Description
Chapter 20-RMX Administration and Utilities
Card Configuration Mode Indicates the MCU configuration as derived from the installed
media cards:
• MPM: Only MPM cards are supported. MPM+ and MPMx
cards in the system are disabled. It is the mode used in
previous RMX versions.
From Version 7.1, MPM media cards are not supported.
• MPM+: Only MPM+ cards are supported. MPM and MPMx
cards in the system are disabled.
• MPMx: Only MPMx cards are supported. MPM and MPM+
cards in the system are disabled.
Note: When started with Version 7.0 installed, the RMX enters
MPM+ mode by default, even if no media cards are installed:
• The RMX only switches between MPM, MPM+ and MPMx
Card Configuration Modes if MPM, MPM+ or MPMx cards are
removed or swapped while it is powered on.
• The Card Configuration Mode switch occurs during the next
restart.
• Installing or swapping MPM, MPM+ or MPMx cards while the
system is off will not cause a mode switch when the system is
restarted - it will restart in the Card Configuration Mode that
was active previous to powering down.
• The RMX only switches between MPM, MPM+ and MPMx Card Configuration Modes if MPM /
MPM+ / MPMx cards are removed or swapped while it is running.
• The Card Configuration Mode switch occurs during the next restart.
• Installing or swapping MPM / MPM+ / MPMx cards while the system is off will not cause a mode
switch when the system is restarted – it will restart in the Card Configuration Mode that was
active previous to powering down.
• From Version 7.1, MPM media cards are not supported.
Polycom, Inc. 20-25