RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

The Fast Configuration Wizard starts.
Appendix G-Configuring Direct Connections to RMX
If no USB key is detected and either: this is the First Time Power-up or the Default IP
Service has been deleted and the RMX has been reset, the following dialog box is
displayed:
For more information about First-time Power-up and the Fast Configuration Wizard see
the RMX 1500/2000/4000 Getting Started Guide, "Procedure 1: First-time Power-up” on
page 2-24.
5 Enter the following parameters using the information supplied by your network
administrator:
— Control Unit IP Address
— Shelf Management IP Address
— Control Unit Subnet Mask
— Default Router IP Address
6 Click the Save & Close button.
The system prompts you to sign in with the new Control Unit IP Address.
7 Disconnect the LAN cable between the workstation and the LAN 2 Port on the RMX’s
back panel.
8 Connect LAN 2 Port on the RMX’s back panel to the local network using a LAN cable.
9 Enter the new Control Unit IP Address in the browser’s address line, using a workstation
on the local network, and press Enter to start the RMX Web Client application.
10 In the RMX Web Client Login screen, enter the default Username (POLYCOM) and
Password (POLYCOM) and click the Login button.
Polycom, Inc. G-5