RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Polycom 1500/RMX 2000/4000 Administrator’s Guide
Table C-11 Event fields for Event 5 - ISDN/PSTN PARTICIPANT CONNECTED (Continued)
Field Description
Secondary Cause Note: This field is only relevant to ISDN video participants and only if the
Participant Status is Secondary.
Secondary Cause
(cont.)
The cause for the secondary connection (not being able to connect the video
channels), as follows:
0 - Default
11 - The incoming video parameters are not compatible with the conference
video parameters
12 - H.323 card failure
13 - The conference video settings are not compatible with the endpoint
capabilities
14 - The new conference settings are not compatible with the endpoint
capabilities
15 - Video stream violation due to incompatible annexes or other
discrepancy.
16 - Inadequate video resources
17 - When moved to a Transcoding or Video Switching conference, the
participant’s video capabilities are not supported by the video cards
18 - Video connection could not be established
24 - The endpoint closed its video channels
25 - The participant video settings are not compatible with the conference
protocol
26 - The endpoint could not re-open the video channel after the conference
video mode was changed
27 - The gatekeeper approved a lower bandwidth than requested
28 - Video connection for the SIP participant is temporarily unavailable
29 - AVF problem. Insufficient bandwidth.
30 - H2.39 bandwidth mismatch
255 - Other
Table C-12 Event Fields for Event 7 - PARTICIPANT DISCONNECTED
Field Description
Participant Name The name of the participant.
Participant ID The identification number assigned to the participant by the MCU.
Call Disconnection
Cause
Q931 Disconnect
Cause
The disconnection cause. For more information about possible values, see
Table C-38, “Disconnection Cause Values,” on page C-37.
If the disconnection cause is “No Network Connection” or “Participant Hang
Up”, then this field indicates the Q931 disconnect cause.
C-18 Polycom, Inc.