RMX 2000 Administrator's Guide Version 7.6.1 - Polycom

Table 12 supported current Polycom products
HDX Systems:
• 7000 HD Rev C
• 8000 HD Rev B
• 9006
• 4500
The following Polycom peripheral:
• Polycom Touch Control
Appendix J-Polycom Open Collaboration Network (POCN)
V3.0.3
Requires TIP option key.
The following procedures 1 - 16 are a summary of the configuration procedures.
The detailed procedures 1 - 16 begin with “Procedure 1: Set the
MIN_TIP_COMPATIBILITY_LINE_RATE System Flag” on page 16.
RMX
1 Set the MIN_TIP_COMPATIBILITY_LINE_RATE System Flag
2 Configuring the RMX to statically route outbound SIP calls to DMA or CUCM
3 Configuring the RMX’s H.323 Network Service to register with CMA gatekeeper
4 Configuring a TIP enabled Profile on the RMX
5 Configuring an Ad Hoc Entry Queue on the RMX if DMA is not used
6 Configuring a Meeting Room on the RMX
7 Configuring Participant Properties for dial out calls
DMA
If DMA is present in the configuration perform procedures 8 and 9, otherwise skip to
procedure 10.
8 Configuring DMA to route SIP calls to CUCM
9 Configuring a Virtual Meeting Room (VMR)
The procedures for configuring DMA are described in detail in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
CMA
10 Configuring CMA to route H.323 calls to RMX
11 Configuring CMA for use with Cisco IOS Gatekeeper (Neighbored)
12 Configuring CMA to route H.323 calls to CUCM
13 Configuring CMA to route non-H.323 calls to CUCM
The procedures for configuring CMA are described in detail in the Polycom Unified
Communications Deployment Guide for Cisco Environments.
Polycom, Inc. J-15
1.3.0
SIP ONLY (no TIP support) Version(s)
Spectralink wireless phones 8020/8030
Polycom VVX 1500 V4.0
Polycom VVX 1500 C V3.3.1
KIRK Wireless Server 300/600v3/6000